FL3-RED LED Bulb Electronic Flasher
Electronic LED Flashers have no minimum load-12VDC. Eliminates the need for load resistors, turn signals will flash at normal rate with or without LED bulbs. Use the Flasher Selection Guide to determine the correct Flasher for your vehicle.
Product Specifications
Clicking Sound No Polarized Yes
Type LED Car Flasher Typical Vehicle Type American
Replaces Stock Bulb: FLASHER
Dimensions: 6.69cm(2.63″) x 2.84cm(1.12″) x 2.84cm(1.12″)
Material
Case: Nylon pa6,6 + 15% Black Fastons 1, 2 & 5: Cu Zn
Case: Nylon pa6,6 + 15% Black Bracket: Ck 67 Hardness 490±525HV1 Phospated White
Technical Characteristics
Nominal Voltage Un 12V
Operating Voltage Uop 10V…15V
Pull-in Voltage Ui ≤10V@Tp
Test Voltage Up 13V±0.2V
Test Temperature Tp 20°C±2°C
Switch Power An 0.1…30W @ Up
Max. Power Am MAX. 30W
Flashing Frequency f 80 TIMES/min±10%
Operating Temperature Top -40°C…80°C
Storage Temperature Tsto +110°C/2h
Life Time 400h/Wn
CONTINUOUS/CONTINUO
Operates Silently Yes
Important Notes concerning LED Flashers: These flashers do not replace all flasher units. Before you order, please see the pin outs of our flashers in the More Info page and compare with the one you are replacing. Click the part numbers for complete specifications. You can usually find your flasher pin out printed right on your flasher. Failure to check this and installation in an incompatible vehicle can blow your fuse, destroy the flasher and void the flasher warranty.
Notes: Some of these flashers operate silently, they do not make the familiar clicking sound when operating. One solution is to connect a common automotive relay to the output along with your LED bulbs.
